Hello,

my name is Joerg Horn, I bought easy-ECU 3+ from K-Jet Killers. Becaus I get no support from there, I hop, that you can help me with my problem.
I use your ECU for an Audi 5 cylinder 10V turbo from 1988.
Following setup, checked with ECU-prog 3.8 and firmware 3.8 on ECU:

- Injectors for sequential injection connectet to right connector 3B 3C 1E 1D 2F
- Active ignition coils for sequential ignition connected to right connector 1F 2F 3G 3H 3E

- sensor IAT ---> works
- sensor CLT ---> works
- sensor TPS ---> works
- Nock-sensor Bosch ---> works
- Lambda (Bosch LSU 4.9)---> works
- Hall-sensor on distributor (5-windows)---> works
- AND 60-2 trigger wheel on crankshaft with hall sensor ---> SENSOR SIGNAL OK,BUT NO SIGNAL IN ECU

I only get RPM-signal from camshaft (Hall-sensor 5 windows).
In my oppinion there is a problem with firmware, because all sensors work, but crankshaft-signal has no effect.
I have no possibility to choose sequential injection in setup-program.

It would be great, if you could help me.

Thank you very much and best regards


Joerg Horn

As far as I know, when placing an order it is supposedly necessary to specify what output parameters the driver should have. With k jet killers was a problem because the man who handles it was sick and only now there is some contact. Check that you have well connected outputs from the driver according to the pinologies, The sequence uses the passive coil output