-------------------------------------------------------------------------------------------- *** EasyEcu 3+ firmware 3.8.3.13 (07.07.2019) *** CAUTION! Firmware is compatible with EcuProg 3.8.3, Build date: Jan 07 2019 21:51:56 In this version maps and configuration saving in memory of ECU has been changed. Make a copy of configuration and maps before update will be performed. After update restore configuration and maps from saved project. New features: - fifth ignition event has been added (Ignition event 5). It allows run V10 or R5 engines. R5 settings as V10 but run 5 individual coils in wasted spark mode - Flat shift has bee added, activation on input I/O #1 (pin 1E right connector) - measurement of addition temperature (e.g. oil temp) on NTC input (pin 1H right connector) hes been added - infinitely adjustable (custom value) tacho signal divider has been added - multiplier for PWM Boost map dependent of interpolation signal between sets of maps #1 i #2 has been added New parameters: - Ignition -> Ignition outputs -> Ignition event 5 - Sport -> Flat shift -> Active flat shift - Sport -> Flat shift -> Flat shift RPM - Sensor calibration -> NTC sensor - Boost settings -> PWM multiplier for map #2 - Outputs -> Tacho custom divider Fixed issues: --------------------------------------------------------------------------------------------